The General Duty Clause is a provision in the US Occupational Safety and Health Act that requires employers to keep the workplace free from recognized hazards likely to cause death or serious physical harm, even when no specific OSHA standard covers that hazard.
- Section 5(a)(1) of the OSH Act is the formal source of the General Duty Clause.
- It fills gaps where no specific OSHA standard exists for a particular hazard.
- OSHA must prove the hazard was recognized, likely to cause serious harm, and that a feasible method of correction existed.
- Citations under the clause often follow serious incidents involving novel or uncommon hazards.
FAQs
Q1. What is the difference between the General Duty Clause and a specific OSHA standard?
A specific OSHA standard sets detailed requirements for a named hazard, while the General Duty Clause acts as a catch-all, allowing OSHA to cite an employer for a recognized serious hazard even when no specific standard addresses it directly.
Q2. What must OSHA prove to issue a General Duty Clause citation?
OSHA must prove the hazard was recognized by the employer or industry, was likely to cause death or serious physical harm, and that a feasible and useful method existed to correct it, before issuing a General Duty Clause citation.
Q3. Does the UK have an equivalent to the General Duty Clause?
The UK’s Health and Safety at Work etc. Act 1974 contains a broadly similar general duty, requiring employers to ensure the health, safety, and welfare of employees so far as is reasonably practicable, even without a specific regulation covering every hazard.
Q4. When does OSHA use the General Duty Clause instead of a specific standard?
OSHA uses the General Duty Clause when a serious, recognized hazard exists but no specific standard directly addresses it, often in cases involving newer equipment, processes, or workplace risks that regulations have not yet caught up to.
Q5. Can an employer be cited under the General Duty Clause for a hazard covered by another standard?
An employer generally cannot be cited under the General Duty Clause for a hazard already covered by a specific OSHA standard, since the clause is meant to address gaps rather than duplicate existing requirements.